| Batch Capacity Dry Solids Basis |
Shows the range of solids (weight) normally collected on a screen. |
 |
| Pressure Rating |
Overall vessel pressure rating - needed for steam sterilizing process. |
|
| Product Screen Nominal Diameter / Area |
Area of screen is calculated based on total inside diameter of frame walls. |
|
| Scalping Screen Nominal Diameter / Area |
Area of screen is calculated based on total inside diameter of frame walls. |
|
| Standard Inlet Diameter / Capacity |
Capacity is maximum hydraulic feed rate. (Actual capacity based on mesh.) |
|
| Standard Outlet Diameter / Capacity |
Capacity is maximum hydraulic discharge rate. (Actual capacity based on mesh.) |
|
| Product Discharge Diameter / Rate |
Maximum steady state solids discharge rate from screen hole with plug open. |
|
| Maximum Screen Delta P |
The maximum pressure differential across the screen. |
|
| Drying Gas Flow Rate |
The range of purge gas flow recommended for optimal drying of the wet cake. |
|
| Drying Vacuum |
Range of applied vacuum used in combination with the purge gas to achieve optimum drying. |
|
| Flexible Connector Length, Minimum |
Length required at hoses are needed to withstand vacuum. Flexible hose length required to isolate vibrating chamber. |
|
| Motion Generator Power |
Motor rating. |
|
| Motion Generator (RPM) |
Standard speed is 1800 RPM, but listed speeds are available (consult Sweco for weight settings). |
|
| Controller Voltage |
Input voltage required to support the Sweco motion controller (inverter). |
|
| Controller Input Phase |
Shows if controller demands single or three phase power (all motors are three phase). |
Home
